Advantage Pool Pumps Owner's Manual download pdf (Page 7)

1. Be sure all connections have been made and are secure.

2. Make sure the hair and lint pot of the pump is filled with water. (FAILURE TO FILL THE HAIR AND

LINT POT WITH WATER WILL RESULT IN DAMAGE TO THE PUMP AND PUMP SEAL). Failure

to do so will void warranty.

3. OPEN THE MANUAL AIR RELIEF VALVE 1/2 TURN COUNTERCLOCKWISE TO RELEASE AIR.

4. STAND CLEAR OF THE FILTER. Start pump allowing the filter ta

nk to fill with water. Close the high

flow air relief valve after a steady stream of water appears.

5. Your filter has now started its filter cycle. You should check that the water is returning to the pool and take

note of the operating pressure. My original starting pressure is ______________ PSI with the filter clean.

6. Check the system for water leaks. If a leak is found, shut off pump before corr

ecting leak.

WARNING

THIS FILTER OPERATES UNDER HIGH PRESSURE. WHEN ANY PART OF THE

CIRCULATING SYSTEM (e.g. LOCK RING, PUMP, FILTER, VALVES, ETC.) IS

SERVICED, AIR CAN ENTER THE SYSTEM AND BECOME PRESSURIZED.

PRESSURIZED AIR CAN CAUSE THE LID TO BE BLOWN OFF WHICH CAN

RESULT IN SEVERE INJURY, DEATH, OR PROPERTY DAMAGE.

7. As the filter removes dirt and impurities from the pool water, the accumulation wi

ll cause the filter pressure

to rise and the flow to diminish. When the pressure gauge reading is 8 to 10 PSI higher than the clean filter

reading noted above, it is time to clean the filter’s element grids, see SECTION V. CLEANING THE FILTER.

SECTION V. CLEANING THE FILTER

1. Cleaning frequency will vary from pool to pool and with other factors such as weather conditions, heavy

rains, dust pollen, bather load and water chemistry.

a. Check the pressure gauge reading on a regular basis and when the pressure gauge reading increases

8 to 10 PSI over the initial clean filter reading, it is time to clean your CARTRIDGE ELEMENT.

2. Turn the pump off, shut off any automatic controls to assure that the system is not inadvertently started

during servicing.

3. Plug the skimmer port with a rag. This will preve

nt pool water from running out during servicing.

4. Open Air Relief Valve on top of Filter.

START-UP AND OPERATION

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No comments

Advantage Pool Pumps Owner's Manual Page 7