Advantage I-200 User's Guide download pdf (Page 25)

24 A-61520 April 2005

The Options tab The Options tab allows you to set Image Transfer and Transport

controls.

Image Transfer Order  if you are using simultaneous output

scanning (bi-tonal and color/grayscale) for either side, this option

controls the order in which the scanner returns image data. For

example, if you are scanning color and bi-tonal and you select Bi-tonal

Image, the scanner will return the bi-tonal front image, then the front

color image.

Transport Timeout  allows you to set a transport timeout value. This

value is the amount of time the scanner will wait after the last document

enters the transport before the transport timeout action is taken. You

can specify a time delay setting from 1 to 30 seconds. If this option is

disabled, the transport will continue to run until it is stopped by the host.

NOTE: Setting a long transport timeout value will affect the life of the

tires on the feed module and separator module.

Special Document Mode (i280 Scanner only) — enable this option if

you want to scan irregularly shaped documents (e.g., pages with

coupons removed or documents with large holes or cutouts) that would

normally produce unexpected results such as truncated images or

jams.

Energy Saving Control  allows you to set the amount of time the

scanner will remain inactive before the scanner goes into an idle state

(sleep mode). Choices are: (none) or 15 to 60 minutes.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 47 48

No comments

Advantage I-200 User's Guide Page 25