Advantage I-200 User's Guide download pdf (Page 45)

44 A-61520 April 2005

Ultrasonic Detection Sensitivity levels

• Low Sensitivity: this setting is the least aggressive setting and is

less likely to detect labels, poor quality, thick or wrinkled documents

as multi-fed documents.

• Medium Sensitivity: this is the default. Use Medium Sensitivity if

your application has varying document thicknesses or labels

attached to the document. Depending on the label material, most

documents with labels should not be detected as a multi-fed

document.

• High Sensitivity: the most aggressive setting.

Units — defines the primary measurement system. Pixels, Inches,

and Centimeters are available.

Enable Energy Saver — allows you to set the amount of time the

scanner will remain inactive before the scanner goes into an idle state

(sleep mode). Choices are: (none) or 15 to 60 minutes.

Transport timeout  allows you to set a transport timeout value. This

value is the amount of time the scanner will wait after the last document

enters the transport before the transport timeout action is taken. You

can specify a time delay setting from 1 to 30 seconds. If this option is

disabled, the transport will continue to run until it is stopped by the host.

Setting a long transport timeout value will affect the life of the tires on

the feed module and separator module

Special Document Mode (i280 Scanner only) — enable this option if

you want to scan irregularly shaped documents (e.g., pages with

coupons removed or documents with large holes or cutouts) that would

normally produce unexpected results such as truncated images or

jams.

1 2 ... 40 41 42 43 44 45 46 47 48

No comments

Advantage I-200 User's Guide Page 45