Advantage Pool Pumps Owner's Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 9
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
d. If a motor has become wet - let it dry before operating. Do not allow the pump
to operate if it has been flooded.
e. If a motor has been damaged by water it voids the motor warranty.
NOTE: DO NOT wrap motor with plastic of other air tight materials. The motor may be covered during
a storm, for winter storage, etc., but never when operating, or expecting operation.
SERVICE
WARNING: Risk of electrical shock or electrocution.
This pool pump must be installed by a licensed or certified electrician or a qualified pool
serviceman in accordance with the National Electrical Code and all applicable local codes
and ordinances. Improper installation will create an electrical hazard which could result in
death or damage to property.
Always disconnect power to the pool pump at the circuit breaker before servicing the
pump. Failure to do so could result in death or serious injury to serviceman, pool users or others due to
electric shock.
WARNING: DO NOT open the strainer pot if pump fails to prime or if pump has been operating
without water in the strainer pot. Pumps operated in these circumstances may experience a build up of vapor
pressure and may contain scalding hot water. Opening the pump may cause serious personal injury. In order
to avoid the possibility of personal injury, make sure the suction and discharge valves are open and strainer
pot temperature is cool to touch, then with extreme caution.
PUMP DISASSEMBLY
1. All moving parts are located in the rear sub-assembly of this pump.
Tools required:
a. 1/2 inch open end wrench.
b. 9/16 inch open end wrench.
c. Flat and Phillips head screwdrivers.
2. To remove and repair the motor sub-assembly perform the following procedures.
a. Turn off the pump circuit breaker at the main panel.
b. Drain the pump by removing the drain plugs.
c. Remove the 6 bolts that hold the main pump body (strainer pot/volute) to the
rear sub-assembly.
d. GENTLY pull the two pump halves apart, removing the rear sub-assembly.
e. Remove the diffuser.
CAUTION: Be sure not to scratch or mar the polished seal faces. Seal will leak if faces are damaged.
6
Page view 5
1 2 3 4 5 6 7 8 9

Comments to this Manuals

No comments