Advantage Pool Pumps Owner's Manual download pdf (Page 7)

f. Hold the impeller securely in place and remove the impeller lock screw by

using a Phillips head screwdriver. The screw is a left-handed thread and loosens

in a clockwise direction.

g. Remove the shaft cap located at the back of the motor and hold the shaft secure

with a flat-head screwdriver (Century) or 7/16 inch open-end wrench (Franklin).

h. To unscrew the impeller from the shaft, twist the impeller counter clockwise.

i. Remove the four bolts from the seal plate to the motor, using a 9/16 inch

wrench.

j. Place the seal plate face down on a flat surface and tap out the carbon/spring

seal.

k. Clean the seal plate, seal housing, and motor shaft.

PUMP REASSEMBLY/SEAL REPLACEMENT – SEE FIGURE 4

1. When installing the replacement

ceramic/carbon seal, use silicone

sealant on the metal portion, before

pressing into the seal plate.

2. Before installing the ceramic section of

the seal into the impeller, be sure the

impeller is clean. Use a light density

soap and water to clean the seal. Press

the seal into the impeller with your

thumbs and wipe off the ceramic and

carbon faces with a clean cloth.

3. Remount the seal plate to the motor.

4. Screw the impeller onto the motor shaft.

5. Screw in the impeller lock screw (counter clockwise to tighten).

6. Remount the diffuser onto the seal plate.

7. Grease the O-ring with Teflon or silicone.

8. Assemble the motor sub-assembly to the strainer pot-pump body. Do not tighten down any

of the bolts until all 6 bolts are in place and finger tight.

9. Fill the pump with water.

10. Reinstall the pump lid by turning clockwise until hand tight (Do not over tighten with tools).

Figure 4

O-ring

Impeller

Pump

Seal

Face Plate

Motor Shaft

Hex

Bolts

Gasket

Screw

Diffuser Assembly

1 2 3 4 5 6 7 8 9

Comments to this Manuals

No comments

Advantage Pool Pumps Owner's Manual Page 7

Comments to this Manuals

Related products and manuals for Above ground pool accessories Advantage Pool Pumps